The Postgraduate in 3D Printing Architecture is a 6-month long intensive programme in the field of additive manufacturing of sustainable architecture. Between the use of advanced technology for construction and the desire to develop a holistic design approach to architecture, we engage with different areas of research that include robotic manufacturing, material research and performance-based design. The programme seeks to develop technological and architectural solutions in collaboration with Industry partners to answer the current needs and challenges of our habitat.
Introduction – Hypothesis How can we optimize the geometry of different sections of a 3D-printed wall to adapt to varying levels of solar radiation and insulation requirements, while also reducing material usage and printing time? By deforming the infill patterns of 3D-printed earth walls, it is possible to optimize the thermal transmittance of the walls, … Read more
A Family-Oriented Home While investigating demographics in Austin, we found that more than one quarter of the families there are single-parent households. Of these, the vast majority are single mothers. With these statistics in mind we arrived at three design considerations: the needs of a single parent household, Austin’s climate, and the unique constraints and … Read more
Table of Contents Abstract Design Previous Research : LIGHT [ AIR ] Tova vs Kibaha Porosity Compositional grid for Kibaha prototype Technical Challenges Material Recyclability Foundation & Cast Overhangs Edges condition Mesh grids Offsets Approach curves & curve order Ventilation Conclusion Abstract The relatively low mechanical strength of earth means that its use in traditional … Read more
Overview In the last week of Phase One TECHNE, comes Architecture, where we used “The light wall”, an earth 3D printed wall that uses light as a performative element, in the design of an architecture project. By modifying the geometry of the wall and analyzing the performance of light going through, we develop a strategy … Read more
Table of Contents — ABSTRACT To deal with the fifth façade, vernacular earth construction introduces different materials to cover horizontal spans. This switch of materials allows the earth to work primarily under compression, avoiding altogether the need to work against gravity and the intrinsic tension that horizontal elements require to be supported. This research follows … Read more
How can we print a multistory student housing facility using earth and what techniques should we use to cover the fifth facade? As 3dpa students studying in Barcelona, we found it quite difficult to find short-term housing in Poblenou with the amenities we required. Here is where we began, with the goal of providing accommodation for all short-term IAAC … Read more
Multiple-story 3d printed earth housing in Barcelona Introduction Milà Earth envisions an earth high-rise building located in Milà i Fontanals street on Vila de Gracia, a high-density neighborhood in Barcelona. An architectural proposal for student housing that aims for vertical densification of the central city. Focusing on using local materials and innovative cutting-edge building technologies, … Read more
Presented is a proposal for building a 3d printed pavilion with biomaterials in Valldaura camp with the main challenge of covering a horizontal 3d printed surface. The project is part of an internal competition during the 3DPA 22/23 postgraduate studies. The winning proposal will be finally built. Several iterations were made as part of the … Read more
Kinetic explorations of the machine over a primary geometry in order to understand the principles and workflow of clay 3D printing on cylinder samples. Machine was an introductory workshop to introduce technologies, techniques, and materiality on deposition modeling and its implication in the design. With the setup of a standard form that could return in … Read more
